D-2100 and D-2300 Strapper

The "New D-2100 & D-2300" machines are capable of an incredible throughput of 50 straps per minute, easy maintenance, outstanding reliability, low energy requirements, and faster warm up time; sure to greatly reduce operational cost.

Propelling Dynaric into the new millennium, these strapping machines are designed and built for the demands of the future, with features never seen before in any strapping machine, especially at the low introductory prices.

The D-2100 and the D-2300 machines are designed without sharp edges; all corners are curved for personnel protection. These machines are equipped with an internal strap dispenser; a stainless steel tension roller and an automatic simple to use strap feed system. The new machines are designed with a new mechanism which allows the machine to automatically discharge any leftover strap in case of a misfeed or when the coil of strapping is finished.

• An open cabinet section allows visibility of internal coil of strap.
  
• The slide table is 40mm W x 5mm H, allowing minimum size packages of 3.5" W x 1.5" H to be strapped.
  
• Operating at 120 volts, single-phase power, and using only 500 watts, these machines will also provide energy and money saving advantages.
  
• At 1.2 seconds per cycle, they are the fastest general-purpose strapping machines available today.
  
• The D-2100 can be set to run with 5mm, 6mm or ¼" strapping.
  
• The D-2300 can be set to run with 9mm, 12mm, 1/2", or 5/8" strapping.
  
• Both of these machines are equipped with all the same benefits and features.

Dynaric, Inc., GlenPointe Centre West, 500 Frank W. Burr Blvd., Teaneck, NJ 07666. Tel: 201-692-7700; Fax: 201-692-7757.