CAP FEEDER

Aidlin fully automatic Cap Feeder combines 3 functions in one machine:

• Bulk Hooper
  
• Elevator
  
• Orientor

Highly efficient cap orientation and plant floor utilization. Aidlin's patented 3 in one Cap Feeder orientates based on the geometry of the closures. Parts are gently lifted up from the bulk hopper. Properly orientated caps continue traveling vertically to the discharge chute. The properly orientated closures are then conveyed to the capper through either a chute or an Aidlin Cap Conveyor.

Features

• Orients plastic or metal closures 20mm. to 120mm
  
• Maximum speed up to 3 000 cpm
  
• Orient Push-Pull Sports caps at rates up to 650 cpm
  
• Quick change-over with patented "Speed bump"
  
• All stainless steel wash-down construction
  
• Variable speed control
  
• Clean-out door to ensure all caps are out of hopper for quick changeover
  
• 20 cubic feet bulk hopper
  
• Left or right hand discharge

Options

• Clear Lexan dust cover on hopper for sanitation
  
• Anti-static belt for metal closures
  
• Low level sensor and signal for hopper replenishment
  
• 40 cubic feet bulk hopper
  
• Dual discharge outlet chute
  
• Dual "T" cleat to accommodate both beverage and sports caps

Benefits

• Large capacity hopper reduces materials handling and labor requirement for replenishment of the feeder
  
• Parts replenishment is done at a safe floor level.
  
• Gentle handling of caps suitable for fragile tamper-evident rings or thin walled closures
  
• Low maintenance
  
• Suitable for placement remotely from the capper, thus conserving floorspace and reducing traffic
  
• Quick changeover to accommodate different size closures. Aidlin Cap Feeder can be connected to Flat Top Air Trans conveyor to allow any remote location of the equipment
  
• From a standard basic modular design, the Aidlin Cap Feeder is adaptable to suit your plant layout and production requirements

Gebo Corporation USA, 6015 31Street East, Bradenton, FL 34203. Tel: 941-727-1400; Fax: 941-727-1200.