Meltcator Hot Melt Roll Coater
Source: The Gluefast Company, Inc.
This new, 120 volt system (220 volts available) is ideal for applying hot melt adhesives onto flat surfaces
This new, 120 volt system (220 volts available) is ideal for applying hot melt adhesives onto flat surfaces. Great for corrugated build-up, gluing foam to foam and foam to corrugated for protective packaging. The unit above shows the optional Pressure Bar Attachment for materials up to 1/2" (1.3 cm) thick. Without the attachment the operator moves the item to be glued over the glue roller. It's glue tank holds about five pounds of hot melt.
An electronically controlled thermostat provides variable temperature control. The speed of the roller is also variable. There is a motor lock-out switch to prevent damage to the motor if it is turned on before the adhesive is molten. This heavy duty roll coater is designed for years of service in a factory setting.
For gluing thick materials the MELTCATOR is available without the pressure bar attachment shown above.
The photo below shows adhesive being applied onto a foam block.
The Gluefast Company, Inc., 3535 Route 66, Building #1, Neptune, NJ 07753. Tel: 732-918-4600; Fax: 732-918-4646.